Primary causes seen thus far:

*   Learn state lost, perform a new door learn.
    
*   Dip switch settings.
    
*   Test switch set to Test instead of Run (might need to disconnect one wire lead to ensure it isn't a stuck switch).
    
*   Close limit reed switch.
    

1.  Not reading at all. Re-position switch to where it reads (may need to bend actuator vertically, they are flimsy).
    
2.  Reads in closed state, but once door close is held it goes out. Re-position switch so it is also active when door close (clutch is picked) button is held.
    

*   CCBN2 dipswitch 3 needs to be in the off position.
    

<br>

<br>

<br>