Elevator 1:

*   DBG wide by 5/16" at initial fish plate, there are no brackets close for adjustment.
    
*   Motor rail bolt retainers not bent
    
*   Bat wing and isolation channel bolts left loose
    
*   Exceptionally noisy and rough ride.
    
*   Gusset nut missing
    
*   Unlocking devices sticking
    
*   Bottom terminal access does not work
    
*   Cartop pushed forward as much as can safely possible, pickup rollers barely engage clutch, will pull out on point load.
    
*   Access not functioning (bottom terminal)
    
*   In car lanterns not functioning
    
*   Proximity switch wired incorrectly
    
*   Ride quality horrendous 
    

<br>

Elevator 2:

*   EBR forcing OSS mode. Behind the installed serial cable a db9 pin was bent.
    
*   <img class="image_resized op-uc-image op-uc-image_inline" style="width:388px;" src="/api/v3/attachments/60/content">
    
*   Proximity switch wired incorrectly
    

<br>

<br>

Elevator 3:

*   DBG off by as much as 7/16&quot;, worst with the starter rails and improved progressively rising up the hatch.
    
*   Cartop misaligned
    
*   Gusset gap excessive
    
*   EBD non functioning, troubleshoot. Result: Phasing reversed and remedied
    
*   In car lanterns not functioning
    

<br>

Elevator 4 (post release):

*   126 fault: 6-30 was set from the factory, not used within NA for this configuration
    
*   189 &amp; 190: E-brake proximity switch started to hang (not drop out immediately). (increased gap a few micrometers)
    

<br>

<br>